Tiny-T (150mm Trident) Bed Version:Revision 2

Tiny-T (150mm Trident) Bed Version:Revision 2We are offering beds up for the Tiny T Project by thiagolocatlli (github) Beds are made out of 6. 35mm thick material and can be gotten in standard or magbed form. 2 tapped holes for ground wire thermistor. Rev1 Dimensions: 150x150x6. 35mm Weight: 1. 2 lbs Magnets: 150C Neodynium Rev2 Dimensions 150x157x6. 35mm Weight: 1. 2 lbs Magnets: 150C Neodynium Lead time, 2 7 days as these beds are made on demand. DXF Available from this link.

full drawing available after units start shipping

They are designed to work with some micro-wobblers that are available on our site - but are not required

Clear or Smoked

35" (9mm approx

The question has been asked about how flat our beds are after heating to 100C

Please note if you have difficulty threading a bolt from the bottom side of the bed

This bed a replacement for the Proforge 4 printer bed and is made out of our Ultraflat 5083 series Cast Tooling plate

Each bed is tested on a granite surface plate prior to magnet installation to determine the flatness after flattening

Side Panels: 283 x 373mm

Length: 254mm

enhancing accuracy and minimizing print failures

Rapid identification